LMI Metering Pump P761-D68HI 1.8 GPH,50 psi,PVC Auto-degas, Manual/pulse Control

Description

LMI Roytronic Series P Metering Pump (AutoPrime de-gassing Head).
1.85 GPH @ 50 PSI, AutoPrime Liquid End D68HI, 115 VAC 50/60 Hz, US Plug.
Pulse Input with Dual Manual Control
Stroke frequency control via pulse signal input, manual stroke length control. Stroke frequency is manually adjustable when in local control. Includes low level float switch input.
General Description
LMI Roytronic Series P chemical metering pumps shall be positive displacement, Liquifram type pumps that are UL and CUL approved. Output volume shall be adjustable while pumps are in operation from zero to maximum capacity.
Pump Controls
Control of Series P7 metering pumps shall be selectable between internal and external pulsing by means of a switch integral with frequency control knob. "External" position to be below lowest internally paced frequency setting. Stroke length shall be adjustable by means of readily accessible dial knob. When in external pulsed mode, Series P7 units shall accept signals without the use of electrical timer or internal timer.
Drive Assembly
The pump drive shall be totally enclosed with no exposed moving parts. Electronics shall be housed in chemical resistant enclosure at the rear of the pump for maximum protection against chemical spillage. Electrical power consumption shall not exceed 22 watts per hour under full speed and maximum pressure conditions. Pump weight shall not exceed 7.6 lbs (3.5 kg).
Pressure Relief
The LMI 4-Function Valve is recommended with a LiquiPro or AutoPrime Liquid End to provide automatic pressure relief.
Materials of Construction
See Specifications tab. Chemical metering pump housing shall be of chemically resistant glass fiber reinforced thermoplastic. All exposed fasteners shall be stainless steel. Valve seat and seal ring shall be renewable by replacing only the combination seat-seal ring or cartridge valve assembly.
Check Valve, Tubing, Connections
A total of 16 ft (4.8 m) of tubing shall be provided per pump complete with compressing connections (on models with tubing connections). A foot valve with integral one piece strainer shall be provided for the suction line (on non-high viscosity models with tubing connections), and an injection check/back pressure valve with 1/2" NPT male connection for the injection point (on models with tubing connections).
Includes: foot valve, ceramic weight, injection check valve, tubing and connection kits
THIS PUMP RETAILS FOR OVER 0.00!!!
FOUND ELSWHERE FOR OVER 0.00!!!
These pumps will soon be obsolete. Get them before they are gone!
(4) pumps available... will consider bulk discount
Not what you are looking for? Check out my other listings!